Drum Reset Instructions for DR-630
Drum Reset Instructions for Brother DR-630
Issue:
The drums cartridge's reset gear did not properly connect and reset the printer's New Toner Sensor. After the drum unit is placed, the reset gear will only operate once, and the position of the gear cannot be reset after that. A manual reset technique is required to reset the Drum Life Display.
Solution:
Follow the solution for the specific printer model you have.
Printer Models: DCP & MFC. DCP-L2520, DCP-L2520DW, DCP-L2540, DCP-L2540DW, MFC-L2680W, MFC-L2700DW, MFC-L2705DW, MFC-L2707DW, MFC-L2720DW, MFC-L2740DW.
1. Open the front toner compartment door
2. Press and hold the "OK" button for a couple of seconds
3. After about 2 seconds, the message “Replace Drum?” will appear
4. For DCP models, press the arrows to reset the drum counter
5. For MFC models, you will press "1" to reset the counter
5. Close the toner compartment door
Printer Models: HL-L2300D, HL-L2320D, HL-L2321D
1. Open the front compartment door
2. Press and hold the "GO" button until all the LEDs light up
3. Once all four LEDs light up, press "GO"
4. Close the front compartment door"
5. And make sure your Drum light is off
Printer Models: HL-L2305W, HL-L2315DW, HL-L2340DW, HL-L2360DN, HL-L2360DW, HL-L2380DW, HL-L2340DW, HL-L2360DW, HL-L2380DW
1. Open the front compartment door
2. Press and hold the "OK" button for about 2 seconds
3. When "Drum Unit" appears on the display, press "OK"
4. Press the arrow button until the display reads "Reset"
5. Reset the counter to zero
6. Close the front compartment door